Removing the Fan MIRA7
What you need
- Phillips Screwdriver
- Cabinet Key
- Allen Key Set
Steps
☠️ WARNING ☠️ Turn OFF and unplug the machine before starting.
- Use the cabinet key to open the Tower left panel on the back of the machine.
Rear of machine - Reach your hand over the fan, and unscrew the four bolts that hold the fan to the cabinet floor.
Four bolts holding fan to the cabinet floor - Locate, by feel, the clamp at the back of the machine that secures the duct hose. With a Phillips head screwdriver, loosen the duct hose clamps, and remove the hose from the back of the machine.
Duct hose clamps - Carefully cut the zipties holding the capacitor to the bottom of the machine, and the zipties holding the wires together.
Cut zipties - Open the lower panel on the right side of the machine with the cabinet key.
Back of machine, lever DIN connectors - Follow the two wires from the fan to the lever DIN connectors. Flip up the orange levers to release the wire and gently pull the wires out of the connector.
- Follow the green and yellow ground wire from the fan to the ground bar. With a Phillips head screwdriver disconnect the ground wire from the ground bar.
Green and yellow ground wire from the fan to the ground bar. - Lift up the fan and remove it from the cabinet.